• Special PVC-flat cable adapted to
  EN 50214 / DIN VDE 0283-2
  Temperature range
  flexing -5°C to +70°C
  fixed installation -40°C to +80°C
• Nominal voltage
  up to 1 mm² U₀/U 300/500 V
  from 1,5 mm² U₀/U 450/750 V
• Test voltage
  up to 1 mm² 2000 V
  from 1,5 mm² 2500 V
• Minimum bending radius
  10x cable thickness
• Radiation resistance
  up to 80x10⁶ cJ/kg (up to 80 Mrad)

• Bare copper-conductor, to
  DIN VDE 0295 cl.5, fine-wire,
  BS 6360 cl.5, IEC 60228 cl.5
• Core insulation of PVC
  compound type TI2 to
  DIN VDE 0207-363-3 / DIN EN 50363-3
• Core identification to DIN VDE 0293
  - up to 5 cores coloured
  - from 7 cores, black with continuous
  white numbering
• Cores laying parallel
• GN-YE conductor
• Outer sheath of special PVC
  compound type TM2 to
  DIN VDE 0207-363-4-1/DIN EN 50363-4-1
• Sheath colour black (RAL 9005)

• Extensively oil resistant, oil-/ chemical
  Resistance - see table Technical
  Informations
• Extremely small bending radius
• High flexibility
• Minimum waste of space
• Packeting possibility
• The materials used in manufacture are
  cadmium-free and contain no silicone
  and free from substances harmful to
  the wetting properties of lacquers

Tests

• PVC self-extinguishing and flame retardant
  acc. to DIN VDE 0482-332-1-2,
  DIN EN 60332-1-2, IEC 60332-1 (equivalent
  DIN VDE 0472 part 804 test method B)
  

• Part no. 27012 (6x4).
• G = with green-yellow conductor
• AWG sizes are approximate equivalent
  values. The actual cross-section is in mm².

PVC type of flat cables are used mainly as trailing cable for crane installations, floor conveyer systems and shelf control units.
Installation notes
Cables reels with flat cables must be transported in standing position on the flange. A bending flexibility can be achieved on a plane surface. For this purpose, the corresponding fitting instructions should be followed.

• Put the cable trolly on the guiding rail or upon carrier beam and push them together at the starting point. The distance between the bedding surface of two cable trollys must be wider than the double thickness of a cable-packet.
  
• During the packeting performance, it must be started with the smaller cross-section which lays on the bedding surface and will be builded successively so that the biggest cross-section is laying on the top.
• Further, be careful of a symmetrical load distribution.
  
• In case of multicore flat cables with small cross-section, smaller than 2,5 mm², is very critical due to its low tensile stress. In such case, you should add 10% reserve wire for calculation.

CE = The product is conformed with the EC Low-Voltage Directive 2006/95/EC.