• Special silicone multicore cable with higher
  heat-resistance range adapted to
  DIN VDE 0250 part 1 and
  DIN VDE 0285-525-2-83/
  DIN EN 50525-2-83
• Temperature range
  -60°C to +180°C
  (for short time +220°C)
• Temperature limit at the conductor
  in operation +180°C
• Nominal voltage U₀/U 300/500 V
• Test voltage 2000 V
• Breakdown voltage min. 5000 V
• Insulation resistance
  min. 200 MOhm x km
• Power rating
  at ambient temperature up to +145°C to
  DIN VDE 0100 for higher temperatures valid:
  150°C - load value 100%
  155°C - load value 91%
  160°C - load value 82%
  165°C - load value 71%
  170°C - load value 58%
  175°C - load value 41%
• Minimum bending radius
  flexing 10x cable Ø
  fixed installation 5x cable Ø
• Radiation resistance
  up to 20x10⁶ cJ/kg (up to 20 Mrad)

• Tinned copper-conductor, to
  DIN VDE 0295 cl.5, fine-wire,
  BS 6360 cl.5, IEC 60228 cl.5
• Core insulation of silicone
• Core identification to DIN VDE 0293-308
  - up to 5 cores coloured
  - from 6 cores, black with continuous
  white numbering
• GN-YE conductor, 3 cores and above
• Cores stranded in layers with
  optimal lay-length
• Sheath of silicone
• Glass fibre tape over the sheath
• Galvanized steel wire outer braiding

• Advantages
  Hardly changes of dielectric strength and
  the insulation resistance also at high
  temperatures, high ignition or flash point,
  in case of fire, forms an insulating layer of
  SiO₂
• Resistant to
  High molecular oils, fats from vegetables
  and animals, alcohols, plasticizers and
  clophenes, diluted acids, lyes and salt
  dissolution, oxidation substances, tropical
  influences and weather, lake water, oxygen
• For laying as a fixed installation only in open
  or ventilated pipe systems as well as in ducts.
  Otherwise the mechanical properties of the
  silicon are reduced by the enclosed air at
  temperatures exceeding 90°C

Tests

• Corrosiveness of combustion gases
  acc. to DIN VDE 0482 part 267,
  DIN EN 50267-2-2, IEC 60754-2
  (equivalent DIN VDE 0472 part 813)
• Behaviour in fire
  no flame propagation acc. to
  DIN VDE 0482-332-1-2,
  DIN EN 60332-1-2,IEC 60332-1 (equivalent
  DIN VDE 0472 part 804 test method B)

• G = with green-yellow conductor
  x = without green-yellow conductor
• AWG sizes are approximate equivalent
  values. The actual cross-section is in mm².