• Special motor power supply cable for
  frequency converters adapted to
  DIN VDE 0250
• Temperature range
  flexing +5°C to +70°C
  fixed installation -40°C to +70°C
• Nominal voltage U₀/U 600/1000 V
• Max. operating voltage
  A.C. and 3-phase 700/1200 V
  DC operation 900/1800 V
• Test voltage 4000 V
• Insulation resistance
  min. 200 MOhm x km
• Coupling resistance
  acc. to different cross-sections
  max. 250 Ohm/km
• Minimum bending radius
  free-movement for outer Ø:
  up to 12 mm: 10x cable Ø
  > 12-20 mm: 15x cable Ø
  > 20 mm: 20x cable Ø
  fixed installation for outer Ø:
  up to 12 mm: 5x cable Ø
  > 12-20 mm: 7,5x cable Ø
  > 20 mm: 10x cable Ø
  
• Radiation-resistance
  up to 80x10⁶ cJ/kg (up to 80 Mrad)

• Bare copper-conductor, to
  DIN VDE 0295 cl.5, fine-wire,
  BS 6360 cl.5, IEC 60228 cl.5
• Core insulation of polyethylene (PE)
• Core identification BN, BK, GY
• GN-YE conductor
  
• Cores stranded in concentric layers
• 1. Screen with special aluminium film
  2. Tinned copper braided screen,
  approx. 85% coverage
• Outer sheath of special PVC
• Sheath colour transparent
• with meter marking

• Low mutual capacitance
• Low coupling resistance for high
  electromagnetic compatibility
• This screened motor supply cable with
  low mutual capacitance of the single cores
  because of the special PE core insulation
  and low screen capacitance enable a low-loss
  transmission of the power compared to
  PVC-sheathed connecting cables
• Due to the optimal screening an
  interference-free operation of
  frequency converters is obtained
  
• The materials used in manufacture are
  cadmium-free and contain no silicone
  and free from substances harmful to
  the wetting properties of lacquers

Tests

• PVC self-extinguishing and flame retardant
  acc. to DIN VDE 0482-332-1-2,
  DIN EN 60332-1-2, IEC 60332-1 (equivalent
  DIN VDE 0472 part 804 test method B)
• Meets EMC requirements acc. to
  EN 55011 and DIN VDE 0875 part 11

• G = with GN-YE conductor
  
• ^**) The current carrying capacity for
  permanent operation at ambient temperature
  of 30°C. For deviating ambient temperatures
  the conversion factors should be used and
  for further see the indication in
  DIN VDE 0298 part 4.
• AWG sizes are approximate equivalent
  values. The actual cross-section is in mm².