10-113276-XXX*
For Open Wire Waterproofing
Similar to the 10-37090 shell in construction,
but substitutes jam nut
mounting. The 10-74900 grommet
seats against the undercut for moisture-
proofing between the clamp
assembly and the shell.

10-37090-XXX*
For Open Wire Waterproofing
A feed-thru shell with an undercut for
retention of the grommet in the 10-
74900 series clamp. The undercut is
notched to prevent grommet slippage.
Mounts to panel with four mounting
bolts.

10-113275-XXX*
For Multi-Conductor Cable
One panel hole will provide mounting
surface for this shell. Tightening the
mounting nut locks the assembly in
place and allows room for attachment
of the 10-305200 clamp.

10-37093-XXX*
For Multi-Conductor Cable
Designed to accommodate cable
entrance through panel wall or bulkhead
and provide attachment for 10-
305200 cable clamp. Mounts to panel
or wall with four mounting bolts.

MS/Standard
application tools

When proprietary crimp contacts are employed rather
than the standard MS approved solder contacts, the following
application tools are recommended for use. There
is a possibility of additional crimping tools other than
those included being available at present or in the future
for this specific application.
Complete instructions for providing reliable crimped wire
to contact terminations and inserting proprietary crimp
contacts in MS/Standard series connectors are available
in publication L-757.

MS/Standard
how to order

MIL-DTL-5015 and MIL-5015 Type (Solder Contacts)
　

MS   3102    A    18 – 3       P     W     (SR)
1            2        3       4        5         6       7          8

1.Connector Type
MS designates Military Standard
CS* designates service class A and C with proprietary
special contact arrangements
SG* designates service class E with proprietary special
contact arrangements
SM* designates service class F and R with proprietary
special contact arrangements
　

2. Connector Style
3100 wall mounting receptacle
3101 cable connecting plug
3102 box mounting receptacle
3106 straight plug
3108 90° plug

3. Service Class
A solid shell for general, non-environmental applications
C solid shell for pressurized applications
E environmental resisting
F environmental resisting with strain relief (MS part number
only)
R lightweight environmental resisting

4., 5.Shell size and insert arrangement - see tables, pages
       22–24.

6. Contact Types
P designates pin contact
S designates socket contact

7. Insert Rotation
“W”, “X”, “Y”, or “Z” designate that insert is rotated in its
shell from normal position. No letter required for normal
(no rotation) position.
　

8. (SR) strain relief for non-military connectors (For MS use
“F” class)
　

* For insert arrangements over 50 and shell size 40 and above.
Exceptions: 36-52, 40-1, 40-9 and 40-56 are MS approved.
　

Consult Amphenol, Sidney, NY for availability of alternate finishes, including black
and olive drab zinc alloys.