進口Teldor FTX系列電信專用鬆式型光纖到戶光纖纜線
(依照中華電信標準分為多套管or束管PJF類)
APPLICATIONS
• FTTP applications – low installation cost, short to medium reach in fiber-to-the-home (FTTH), fiberto-the building (FTTB) or fiber-to-the-Cabinet (FTTCab) applications
• For blowing into protected micro-ducts
CABLE DESCRIPTION
• The cable consists of 6 to 36 elements stranded in up to 3 layers around a dielectric central strength member
and bound in a jacket.
• The elements are usually fiber-containing tubes, 1.5 mm in diameter; however fillers are also used, when needed, to preserve cable geometry. Each tube contains 2 to 12 fibers.
• The tubes are filled with a thixotropic gel to prevent the ingress of water.
• The tubes and fibers are color coded for easy identification.
• Water swelling materials are present between and around the cable core in order to provide full water blocking.
• An aramid-based ripcord is laid under the jacket to aid in cable preparation.
• A black, UV resistant, HDPE jacket is extruded over the cable core.
MECHANICAL PROPERTIES
Typical properties are given next page. Actual properties depend on the cable construction.
OPTICAL PROPERTIES
See the Optical Properties Table.
MATERIALS
See information about the materials used in the Teldor Fiberoptic Cables.
STANDARDS
• Cables tested according to TIA/EIA-455 and IEC-60794-1-2. For details see Test Methods Table.
• Conforms to IEC-60794-5
MARKING
Cables are marked as follows
Teldor - Fiberoptic Cable - Cable Code - RoHS - Length in Meters
or per customer request.
CABLE DIMENSIONS AND WEIGHTS
See list of most frequently ordered cables next page.
ORDERING
You can find the desired cable in the cable list next page or compose your own cable from the Cable Code Definition
and Selection Guide.
Standard cable lengths vary with cable diameter. Other constructions, color codes and materials may be available.
Please contact the Teldor Marketing Department.
Typical Mechanical Properties
Max. Pulling Load |
Depends on cable construction. See cable list below for representative values |
Max. Operating Load |
60% of the Max. Pulling Load |
Max. Compressive Load |
1000 N |
Repeated Impact |
1.0 N.m (J) – 3 x 2 impacts |
Minimum Bending Radius for Installation |
20 times the cable O.D |
Minimum Long Term Bending Radius |
10 times the cable O.D |
Twist (Torsion) — Length |
180°x10 times , 125 times the cable O.D. |
Cyclic Flexing |
100 cycles |
Operating Temperature Range |
-30°C to +70°C |
Storage Temperature Range |
-40°C to +70°C |
線材剖面
下單資訊
keywords: 關鍵字, FTX-F Series Microduct Fiberoptic Cable for Outdoor FTTH Applications 電信專用鬆式型光纖到戶光纖電纜線, 依照中華電信標準分為多套管or束管PJF類, |
|