1. CALEDONIAN-Fire Resistant Coaxial Cables 耐火級低煙無毒同軸電纜線
    CALEDONIAN-Fire Resistant Fire Alarm Cables (950°C 180 minutes)耐火級低煙無毒火警警報電纜線
    Caledonian-Fire Resistant Instrumentation Cables (950°C 180 minutes) 耐火級低煙無毒儀表控制電纜線
    CALEDONIAN-Fire Resistant Optic Fiber Cables 耐火級低煙無毒光纖電纜線
    Caledonian-Fire Resistant Power & Control Cables (950°C 180 minutes) 耐火級低煙無毒電力控制電纜線
    MICC/TRM/TET-Mineral Insulated Heating Units & Cable
    回上一頁

  2. 產品搜尋
    分　類：
    關鍵字：  

    首頁 > > Caledonian-Fire Resistant Instrumentation Cables (950°C 180 minutes) 耐火級低煙無毒儀表控制電纜線

    CALEDONIAN-RE Fire Resistant 300/500V Mica+XLPE or SR Insulated & Overall Screened Multicore Instrumentation 多芯雲母耐火級XLPE或矽橡膠 + 低煙無毒鋁箔隔離儀表控制電纜(可鎧裝)
    看原圖
    		代碼 5543012




    商品編號: CALEDONIAN-RE-C

    CALEDONIAN-RE Fire Resistant 300/500V Mica+XLPE or SR Insulated & Overall Screened Multicore Instrumentation 多芯雲母耐火級XLPE或矽橡膠 + 低煙無毒鋁箔隔離儀表控制電纜(可鎧裝)

    APPLICATION
    The cables are designed, manufactured and tested as data transmission cables for emergency services. These are used for data and voice transmission when high frequency signal has to be assured also in the event of a fire.
    STANDARDS
    Basic design to BS 5308/BS 7629-1
    　




    ★★★★商品說明★★★★

    PRODUCTS

    Fire Resistant Instrumention Cables
    RE-2X(St)H...CI. FE 180 PH30 ( CU/MGT+XLPE/OSCR/LSZH 300/500V Class 2 )
    RE-2G(St)H...CI. FE 180 PH30 ( CU/SR/OSCR/LSZH 300/500V Class 2 )
    RE-2X(St)HSWAH...CI. FE 180 PH30 ( CU/MGT+XLPE/OSCR/LSZH/SWA/LSZH 300/500V Class 2 )
    RE-2G(St)HSWAH...CI. FE 180 PH30 ( CU/SR/OSCR/LSZH/SWA/LSZH 300/500V Class 2 )
    APPLICATION
    The cables are designed, manufactured and tested as data transmission cables for emergency services. These are used for data and voice transmission when high frequency signal has to be assured also in the event of a fire.
    STANDARDS
    Basic design to BS 5308/BS 7629-1
    FIRE PERFORMANCE

    Circuit Integrity

    IEC 60331-21; BS 6387 CWZ; DIN VDE 0472-814(FE180);

    BS 8434-1 (30mins); BS 5839-1 Clause 26 2d; CEI 20-36/2-1; SS229-1; NBN C 30-004 (cat. F3); NF C32-070-2.3(CR1)

    Circuit Integrity with mechanical shock

    EN 50200(PH30); CEI 20-36/4-0

    Circuit Integrity with mechanical shock & water spray

    EN 50200 annex E

    System circuit integrity

    DIN 4102-12, E30 depending on lay system

    Flame Retardance (Single Vertical Wire Test)

    EN 60332-1-2; IEC 60332-1-2; BS EN 60332-1-2;

    VDE 0482-332-1 ; NBN C 30-004 (cat. F1); NF C32-070-2.1(C2);

    CEI 20-35/1-2; EN 50265-2-1*; DIN VDE 0482-265-2-1*

    Reduced Fire Propagation (Vertically-mounted bundled wires & cable test)

    EN 60332-3-24 (cat. C); IEC 60332-3-24; BS EN 60332-3-24; VDE 0482-332-3; NBN C 30-004 (cat. F2); NF C32-070-2.2(C1); CEI 20-22/3-4; EN 50266-2-4*; DIN VDE 0482-266-2-4

    Halogen Free

    IEC 60754-1; EN 50267-2-1; DIN VDE 0482-267-2-1;

    CEI 20-37/2-1 ; BS 6425-1*

    No Corrosive Gas Emission

    IEC 60754-2; EN 50267-2-2; DIN VDE 0482-267-2-2;

    CEI 20-37/2-2 ; BS 6425-2*

    Minimum Smoke Emission

    IEC 61034-1&2; EN 61034 -1&2; DIN VDE 0482-1034-1&2;

    CEI 20-37/3-1&2; EN 50268-1&2*; BS 7622-1&2*

    No Toxic gases

    NES 02-713; NF C 20-454

    Note: Asterisk * denotes superseded standard.
    CABLE CONSTRUCTION
    Conductor: Plain annealed copper wire, stranded according to IEC(EN) 60228 class 2.
    Insulation: Mica glass tape covered by extruded cross-linked XLPE compound or fire resistant silicone rubber compound type EI2 as per BS 7655-1.1.
    Cabling: The cores are cabled together in concentric layers with suitable non-hygroscopic fillers.
    Overall Screen: Aluminum/polyester tape with 0.5mm2 screen (7/0.3mm) with tinned copper drain wire.
    Inner Sheath(optional):Thermoplastic LSZH compound type LTS3 as per BS 7655-6.1
    rmouring(optional): Galvanized steel wire armour
    Outer Sheath: Thermoplastic LSZH compound type LTS3 as per BS 7655-6.1(Thermosetting LSZH compound type SW2-SW4 as per BS 7655-2.6 can be offered.)
    VOLTAGE RATING
    300/500 V
    COLOUR CODE
    Insulation Colour: White with black numberings.
    Sheath Colour: Orange (other colours on request).
    TYPE CODE
    RE- Instrumentation cable H Halogen free & zero halogen
    2X XLPE 2G Silicon Rubber
    (St) Static shield of aluminium tape SWA Steel Wire Armoured
    FE180 Insulation integrity (950°C 180 minutes) CI Circuit integrity
    PH 90 Fire Test for 90 mins at 830°C
    Physical AND THERMAL PROPERTIES
    Temperature range during operation (fixed state): -30°C – +90°C
    Temperature range during installation (mobile state): -20°C – +50°C
    Minimum bending radius: 6 x Overall Diameter (unarmoured cables with silicone rubber insulation)
    8 x Overall Diameter (unarmoured cables with XLPE insulation)
    10 x Overall Diameter (armoured cables)
    Electrical PROPERTIES

    Dielectric test:

    2000 V r.m.s. x 5’ (core/core)

    Insulation Resistance

    XLPE: ≥1000 MΩ x km (at 20°C)
    SR: ≥300 MΩ x km (at 20°C)
    　

    Short circuit Temperature

    XLPE: 250°C
    SR: 350°C

    Fire Resistant Instrumention Cables